Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to config management interface to an ethernet interface?

we have an ASA 5540 that require LAN port for failover. And the only available interface left is the management port. How to config management interface to an ethernet interface?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to config management interface to an ethernet interface?

You can disable the management-only mode on that interface to make it as regualr routable port and use for any other purpose including LAN base failover purposes.

About management interface - 5510 but generally applies to management0/0 itself including 5540

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/intparam.html#wp1057800

configuring LAN base failover

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/intparam.html#wp1057800

Rgds

-Jorge

1 REPLY

Re: How to config management interface to an ethernet interface?

You can disable the management-only mode on that interface to make it as regualr routable port and use for any other purpose including LAN base failover purposes.

About management interface - 5510 but generally applies to management0/0 itself including 5540

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/intparam.html#wp1057800

configuring LAN base failover

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/intparam.html#wp1057800

Rgds

-Jorge

117
Views
5
Helpful
1
Replies
CreatePlease to create content