How to display system security events logs in Cisco router 4980
in order to perform acceptance tests following the installation of a Cisco 4980 router cluster, I need to verify that any system security events are logged and I can diplay them on the CLI output (for example with the #show logging command).
By system security events logs, I mean for example bad authentification on the switch, creation/deletion/modification of a user accoount, telnet connexion attempt while this protocol is not allowed, etc...
With the #show logging command, I have security events related to access-list, or configuration changes (even if these ones are not really verbose on waht have been changed), but no "system" security events.
Here is my logging initial logging configuration on these routers:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...