Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to limit throughput on an interface PIX 515 (7.04)

Hi, I'm looking to limit the max throughput on the outside interface off my pix. I want to be able to keep the outside interface config at 100full, but to restrict the throughput at somethings like 6 mbps.

Is'it possible ?

Thanks !

1 REPLY

Re: How to limit throughput on an interface PIX 515 (7.04)

Hi

You can better watchout for the possible config lines using policing command under your policy map to rate limit the throughput.

for more info on the same do check this link..

http://cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080450b9a.html#wp1045477

regds

229
Views
0
Helpful
1
Replies
CreatePlease to create content