Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how to put an access-list in a serial line using NAT and IPSEC

Hello:

I configured a VPN in a 2600 cisco router using ipsec and NAT. How can I create an access-list in a Serial line to deny some ports to access the internet.

Thanks

Borda.

1 REPLY
Bronze

Re: how to put an access-list in a serial line using NAT and IPS

There is a number of sample config’s on Cisco’s site at:

http://www.cisco.com/cgi-bin/Support/PSP/psp_view.pl?p=Internetworking:IPSec&s=Implementation_and_Configuration#Samples_%26_Tips

You might also want to give TAC a call if you run into issues with the config.

149
Views
0
Helpful
1
Replies
CreatePlease to create content