Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to test port 0 on a Pix 501

I have a Pix 501 running software ver 6.3 that is used to allow vpn connections to a network. One day it stopped letting anyone connect, the vpn client says the remote peer is no longer responding.

I would like to test port 0 on the pix to see if it has gone bad but not sure how. Should it respond to a ping request?

This is my first experience with a Pix device so any advice is appreciated.

Thanks

1 REPLY
Cisco Employee

Re: How to test port 0 on a Pix 501

If it said "remote peer no longer responding" then did you see if the PIX was traffic passing through the firewall.

Where you able to ssh to the firewall?

You should be able to ping if ping is not disabled on the outside interface.

103
Views
5
Helpful
1
Replies
CreatePlease login to create content