Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to turn pdm on from the command line

I have a 501 pix that has had the pdm interface turned off and I need to know how to turn it back on

1 REPLY
New Member

Re: how to turn pdm on from the command line

Run the "setup" cmd even if you already have it configured. This mainly is a wizard to walk you through creating a pub/priv key pair.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801cd841.html#wp1171117

Also make sure you have the http cmd setup properly to allow what pc the PDM is connecting from. This should be setup in the "setup" cmd though.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a9.html#wp1029823

100
Views
0
Helpful
1
Replies