Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to use NAT and PAT together in Cisco IOS

We have /29 routable address space for LAN . We have more than 75 local machines which will be Nat'ed on the router .We were thinking to use first 7 routable IP address on dynamic NAT pool and use remaining one IP for PAT overload. When ., I defined two IP nat inside source command , one with dynamic Nat pool and other with PAT overload . In whaterver order I enter , the router always uses PAT but never uses NAT dynamic pool.

Can anyone suggest me how to configure the router to use both NAT and PAT

  • Other Security Subjects
1 REPLY
Cisco Employee

Re: How to use NAT and PAT together in Cisco IOS

Just use one dynamic NAT pool with overload at the end. What will happen is it will use all the addresses in the pool until it reaches the last one, which will then be used for PAT.

HTH

R/Yusuf

345
Views
0
Helpful
1
Replies