Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I connected, but I cant see anything on the inside.. )-;

I'm configuring a PIX in a test bed. Its Currently set yo with a Win2K Server Behind the PIX,

The Server behind the PIX and get out and Surf the Web.

From a client on the outside I can connect to the PIX via Win2K DUN PPTP and have it register the computer on the network. Its gets a DHCP address from the PIX.

Though the Remote Client cant See (ping) the server or the PIX on the inside.

Any Suggestions on where to look?

Thanks,

Scott<-

  • Other Security Subjects
2 REPLIES
New Member

Re: I connected, but I cant see anything on the inside.. )-;

It sounds like it might be an access-list issue. Check your config and ensure you have something like this:

access-list 101 permit ip 192.168.1.0 255.255.255.0 10.1.1.0 255.255.255.0

ip local pool vpnpool 10.1.1.10-10.1.1.19

global (outside) 1 interface

nat (inside) 0 access-list 101

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

Pierre

New Member

Re: I connected, but I cant see anything on the inside.. )-;

If you figure this one out, please let me know. I am having the same problem

85
Views
0
Helpful
2
Replies
This widget could not be displayed.