Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I could not find the sensor in the object selector

Hi everybody,

I have a sensor appliance 4235 has IDS version 4.1(3) S73 and a VMS 2.2 has been upgrade to VMS 2.2 upgrade 1 and the IDS MC has been upgraded to 1.2.3

i added successfully the sensor to the IDS MC but when i selected the configuration -> settings , i didn't find the sensor which i added all i have seen is the group " Global" and its corresponding settings so i couldn't edit the sensor's signatures.

Please what is the problem?

What are the specific requirments to be able to edit the settings for the sensor.

Regards

1 REPLY
Silver

Re: I could not find the sensor in the object selector

You have to make sure that both have the same version especially the management system as has at least the same or higher. The management system has to know the alerts (signatures) therefore needs the same or higher version than the sensor.

75
Views
0
Helpful
1
Replies
CreatePlease login to create content