Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I need your help

hi engineers ,

i setup IDS along with CSPM ,managed them and configure proper host IDs and ORG IDs and so on .

i think everything is ok ,i can ping the sensor .

but i cann't touch what is sensed in my database ,it is always empty with only three lines ,the last one is "route up "

any comment ,mostly appreciated !

thanks

2 REPLIES
New Member

Re: I need your help

If you have connectivity (i.e. seeing the route up), it may just be that you haven't told the sensor what interface to sniff on.

In CSPM, do a File>Save&Update. Then, go to the Command Tab, and do an "approve now" to push your config out to the sensor.

See the following doc for more details/troubleshooting:

Configuring a Cisco Secure IDS Sensor in CSPM

http://www.cisco.com/warp/public/707/ids2cspm_6117.html

HTH

Jeff

New Member

Re: I need your help

thank u very much ,

at least you said some word .

ciao

101
Views
5
Helpful
2
Replies
CreatePlease to create content