Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I want to have multiple IP address on my Pix 515 Internal Ethernet port

Hi to all

well i am migrating from a watchguard firewall to a Cisco 515 UR. I have multiple networks in my netowrk (6 class fake C). And every class has its own gateway, and the watchguard worked on the routing between these lans since I don't have a layer 3 device yet.

The case is that i need to know what to do in this issue, since the time frame to operate the pix is minimal. All my servers (web, dns, and mail) are now on the inside network. i will migrate them at a later stage of operation.

if anybody can help i would appreciate it a lot.

thanks in advance.

2 REPLIES
New Member

Re: I want to have multiple IP address on my Pix 515 Internal Et

I am afraid that you need a layer 3 device to perform the routing in your network. The Cisco PIX cannot be configured with multiple IP addresses on an interface.

New Member

Re: I want to have multiple IP address on my Pix 515 Internal Et

He is correct, you can only have 1 IP address on the interface. Even if you could have multiple addresses, the PIX is not a router. You can not use the PIX as a router.

99
Views
0
Helpful
2
Replies
CreatePlease login to create content