Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ICMP count packets

Hello,

while troubleshooting, I noticed something that i think it is wrong or unusual.

On my router interface fast1 i have acl 100 inbound and acl 200 outbound; both acl's have permit icmp any any .

When I ping with 4 packets (ping ip -c 4) from inbound, acl 100 counts only one packet and acl 200, 4 packets. Also if I repeat ping the same IP acl 100 count nothing and acl 200 counts 4 packets again. Only if I ping another IP acl 100 will count another packet.

This is counfusing for me, I think acl 100 should count like acl 200 4 packets.

I have a router 1812.

Thank u

1 REPLY
Silver

Re: ICMP count packets

Hi,

Are you orginating those ping packets from the router itself?

Remember that ping packets are "echo packets" in one direction and "echo reply" while returning back.

Enable "debug ip icmp" on the router and look for those packets

HTH

Saju

Pls rate if it helps.

227
Views
0
Helpful
1
Replies
CreatePlease to create content