Ive noticed when configuring the remote hosts area of a sensor via the VMS 2.1 MC that it sets the event destination levels to all. There is no place to specify either alarms, commands, errors, ip logs, as is the case in the config files and the IDM. Does anyone know where this functionality exists in the MC or is it planned for later release. The fact that everytime i configure a sensor via the MC it turns the event destinations to all (alarms,errors,commands,logs) is really unacceptable.
For the configuration file settings that are not supported by MC, it provides a way to add it manually as text input, at Configuration->Settings->Advanced->Unsupported Settings. Here, you can select the configuration file and enter the text, which will be appended to the end of the configuration file. Using this, you can configure the remote host for a sensor for a particular event destination level.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...