When install software 3.0(5)S23 in idsm-1 module fisrt, If I do a attack using attack tools first, idsm-1 can deteck attacking, but i do second and later attacking, no any reponse. I can see these information in Diag mode using show event current command. who can tell me what problem with idsm-1 ?
What signatue is it that's firing? If the signature is set up to FireOnce or Summarize, then it'll only fire the once per source/destination pair, depending on how soon after you run the second test and the value of the ThrottleInterval parameter.
Check the signature parameters, and verify the signatures behaviour using those parameters. Parameter definitions can be found here:
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...