Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM 6000 module... Blocking??

Has anyone used the IDS module for the 6000? I have it installed but all it will do is monitor. It does no blocking. They just released 3.0 for this module, does this support blocking and if so how and what forms of blocking will it do?

Thanks,

Chris Fowler

2 REPLIES
New Member

Re: IDSM 6000 module... Blocking??

Are you using CSPM to manage the sensor? If so, you can configure blocking from CSPM - see http://www.cisco.com/univercd/cc/td/doc/product/ismg/policy/ver22/config/nwdevs.htm#xtocid2325713

New Member

Re: IDSM 6000 module... Blocking??

There are two response actions in the IDS products: Shunning and TCP resets.

Shunning is supported by both the appliance and the module in the 3.0 release. TCP resets are not supported in the module, only the appliance.

118
Views
0
Helpful
2
Replies
CreatePlease to create content