Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSM configure error at 6513

Hello,

I install 4 isdm2 at 6513. But I have twice experience for the fllowing error when I use IEV to configure the idsm.

The message is :

IOException when try to get certificate: socket closed.

One of them , I erase IDS configure and re-setup it , it work find .

But the other can not work.

I face much problem in IDSM. Could you help me some information to enhance my IDSM skill.

Thanks

1 REPLY
New Member

Re: IDSM configure error at 6513

This sounds like an older bug, research it and see if it applies to your situation?

CSCdy14263:

IEV Postoffice Active Directory Problem

Symptom: When IEV is installed on a Windows computer with active directory running and you are logged in as an active directory user, IEV does not allow you to add/modify/delete devices through the GUI. You receive an "Error timeout" message if you try to configure the device. The communications service, Postoffice, is running as a service, and the nrget/nrexec utility used by IEV to configure devices is running as an active directory user. These two components cannot communicate successfully through semaphore.

90
Views
0
Helpful
1
Replies
CreatePlease login to create content