I am getting ready to apply the service pack to my IDSM and I have the Cisco Press "Cisco Secure Intrusion Detection System. My IDSM is currently at version 3.0(3)S13 and I want to upgrade to the new ver. 3.0(4)s20. I changed the boot device and did a reset and I am now in the maintenace mode. I do a config t and type appy servicepack site (ftp ip Address) user (ftp user id) dir (directory) file IDSM-sp-3.0-4-S20.exe This does not work. Apply is an unrecognized command. Other than the book I can not find any directions on how to do this. Anyone else having problems updating the IDSM?
You do not need to reboot into maintenance mode to load a service pack or signature update. Change your booting back and when it comes back up go into global config mode on the IDSM and apply the service pack from there using the apply command.
When you want to install a servie pack for your IDSM you don't have to boot at maintenance mode , you have to be at nor mal boot mode they goto configuration mode by type conf t then use this command :
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...