Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IDSMC Signatures Error

On the IDSMC, I added a 4.X sensor. Then I navigated to the signatures selection with the sensor as my object. For some reason the signatures listed were blank. All I saw was this:

General 0 of 0

Custom 0 of 0

I tried to upgrade the director and sensor to S42 (they were at S37) to see if the signatures appeared there, but they did not. When I connected a 3.X sensor the signatures showed up fine.

1 REPLY

Re: IDSMC Signatures Error

Eric sounds like you and the lady who posted this might have the same problem... I am trying to get it to replicate at my house but I haven't had any luck yet. http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.eea1bbf I will let you know if I see anything.

110
Views
0
Helpful
1
Replies