Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
gda
New Member

Import PIX 501 config to ASA 5505

Is there anything special that needs to take place to Import a PIX 501 (IOS Version 6.3) config to an ASA 5505 appliance or is it as simple as uploading the config?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Import PIX 501 config to ASA 5505

Greg

Not it's not unfortunately because your pix is running 6.4 and the ASA 5505 will be running a minimum of 7.x code and there were quite a few changes. Note that a lot of existing commands would work but some won't. Attached is a link to a doc for upgrading from pix to ASA which talks about both a manual method and a tool assisted version -

http://www.cisco.com/en/US/docs/security/asa/migration/guide/pix2asa.html

Jon

2 REPLIES
Hall of Fame Super Blue

Re: Import PIX 501 config to ASA 5505

Greg

Not it's not unfortunately because your pix is running 6.4 and the ASA 5505 will be running a minimum of 7.x code and there were quite a few changes. Note that a lot of existing commands would work but some won't. Attached is a link to a doc for upgrading from pix to ASA which talks about both a manual method and a tool assisted version -

http://www.cisco.com/en/US/docs/security/asa/migration/guide/pix2asa.html

Jon

gda
New Member

Re: Import PIX 501 config to ASA 5505

Thanks Jon, I kind of suspected that. I will take a look at the link in detail and go from there. Thanks again for your help!

699
Views
0
Helpful
2
Replies
CreatePlease to create content