Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Importing into VMS

I have a new install of VMS 2.2 and am trying to make the initial import of Pix devices. All of the Pix I am working with are using SSH with TACACS authentication. I try using my TACACS account with the import but it doesn't pull the config from the device, says it cannot talk to the Pix. I can connect to the Pix with SSH and authenticate with TACACS fine when going into it directly. If I disable SSH authentication and use the default username of pix and the local enable password in the Pix it works. What do I have mis-configured to stop this from working?

1 REPLY
Silver

Re: Importing into VMS

Not sure about this but I remember reading somewhere that this should be done locally only. You should also refer to 'Important Notes About Importing Devices' at http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/mgt_pix/fwmc12/ug/net_asst.htm#1094007

76
Views
0
Helpful
1
Replies
CreatePlease login to create content