Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Increase in block messages since 6.3 install

This past weekend I upgraded the PIX515 from 6.2.2 to 6.3.1. Ever since then I have noticed a high number of error messages with the code %PIX-3-106001. I have noticed that the large bulk of these messages have the following conditions: TCP traffic coming from port 80 on Akamai servers on the Internet going to high number ports on my PAT address. Any one have any insight into what is going on with these errors. I am not getting any complaints from users just a lot of syslog messages.

2 REPLIES
Cisco Employee

Re: Increase in block messages since 6.3 install

Please refer to the above pdf for more info on the above error.

Hope this helps.

yatin

Community Member

Re: Increase in block messages since 6.3 install

What PDF?

93
Views
0
Helpful
2
Replies
CreatePlease to create content