Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

inspect ftp on 5520

configuring my new 5520 and ran the output interperte on it. states : WARNING: FTP inspection engine is disabled. Outbound users will be able to start

connections only in passive mode, and all inbound FTP will be disabled.

TRY THIS: Enable FTP inspection engine using the 'inspect ftp' command in class

configuration mode

im sure this isnt complicated, but some of the commands I found on cisco site arent working..... please advise

thanks

1 REPLY
New Member

Re: inspect ftp on 5520

Near the very bottom of the config, it should have the following

policy-map global_policy

class inspection_default

inspect ftp

If the inspect command is not present, and your question implies it is not, then add these three lines in config mode, and it should be fixed.

If not, then post the config, and I will take another look.

Regards,

Iain

115
Views
0
Helpful
1
Replies