Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Install CCA in HP DL140 G3

Hi,

I am try to install CCA Manager and Server 4.1.1 in a Server HP Proliant DL140 G3. The first time I put enter and I lose the keyborad and mouse. After that I found a bug (CSCsg98960) and the solution was to put "DL140" and after enter. OK now I have Keybord and mouse but the following error occurer "An error has occurred - no valid devices were found on which to create new filesystems. Please check your hardware for the cause of the problem"

Does anyone had the same issue?

2 REPLIES
Silver

Re: Install CCA in HP DL140 G3

Upgrades to 4.1(1) from previous versions are not affected by this bug.

Workaround

At the boot prompt that appears during installation, enter "DL140" and then .

Cisco Clean Access Installer (C) 2006 Cisco Systems, Inc.

Welcome to the Cisco Clean Access Installer!

- To install a Cisco Clean Access device, press the

key.

- To install a Cisco Clean Access device over a serial

console, enter serial at the boot prompt and press the

key.

boot: DL140

http://www.cisco.com/en/US/docs/security/nac/appliance/release_notes/411/411rn.html

New Member

Re: Install CCA in HP DL140 G3

Hello,

I put DL140 and the keybord issue was solved, but another error occurs - "An error has occurred - no valid devices were found on which to create new filesystems. Please check your hardware for the cause of the problem"

102
Views
0
Helpful
2
Replies
CreatePlease to create content