Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Install cisco security manager

Good morning:

I adquire a CSM license and need install, only have one server and this is installed LMS 3.2.

Follow the installation instructions, i found that this CSM can't be installed in the same server that LMS.

This is the paragraph:

"We do not support the coexistence of Security Manager with any third-party software or other Cisco software (including any CiscoWorks-branded “solution” or “bundle,” such as the LAN Management Solution [LMS] or the VPN/Security Management Solution [VMS]), unless we state explicitly otherwise in this guide or at http://www.cisco.com/go/csmanager

"

Someone can tell me if this is definitive or can install both in the same server.

Thank's in advanced

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Install cisco security manager

No problem at all :). Please rate if you find the posts helpful.

Regards

Farrukh

3 REPLIES

Re: Install cisco security manager

Yes both cannot be installed on the same server. Even if you manage it by some 'fancy' trick, it won't be supported by Cisco TAC. If you have only one physical server available, consider VMWARE. Regards

Farrukh

New Member

Re: Install cisco security manager

Farrukh thank you very much.

Re: Install cisco security manager

No problem at all :). Please rate if you find the posts helpful.

Regards

Farrukh

178
Views
0
Helpful
3
Replies
CreatePlease to create content