Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Installing 4th Ethernet interface in PIX classic

I am going to install a 4th nic in my pix classic and want to know if there are any issues I need to worry about. I currently have an inside, outside and dmz interface and am adding this 4th card for a 2nd dmz. The pix will auto detect the card and then from there I can define how I want the card to be used, inside, outside, dmz ect...., is this right?

1 REPLY
Community Member

Re: Installing 4th Ethernet interface in PIX classic

The the restriction will be your license. At the enable prompt check

show version

Licensed Features:

Failover: Enabled

VPN-DES: Enabled

VPN-3DES: Disabled

Maximum Interfaces: 6 **** This is what you need to check

74
Views
0
Helpful
1
Replies
CreatePlease to create content