Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

InternVLAN rules on PIX506

Hi all,

I need to build up a DMZ with a PIX506. My idea is to make a trunk between PIX and switch, assign a VLAN for the DMZ.

Mi question is, can PIX506 handle firewall-rules between the VLAN's (internal <-> dmz)?

Thank's,

Norbert

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: InternVLAN rules on PIX506

Norbert

Not sure what you are asking here. The 506E supports up to 2 vlans on an interface so you can do what you want. Each vlan interface is treated as a physically separate interface in terms of security levels/access-lists etc.

So if you have an inside and a DMZ on the same interface you can apply separate access-lists to each interface.

Does this answer your question ?

Jon

2 REPLIES
Hall of Fame Super Blue

Re: InternVLAN rules on PIX506

Norbert

Not sure what you are asking here. The 506E supports up to 2 vlans on an interface so you can do what you want. Each vlan interface is treated as a physically separate interface in terms of security levels/access-lists etc.

So if you have an inside and a DMZ on the same interface you can apply separate access-lists to each interface.

Does this answer your question ?

Jon

New Member

Re: InternVLAN rules on PIX506

Jon

Thank's for the answer.

Yes I want to control the traffic between DMZ (VLAN-xx)<-> inside (VLAN-yy) over the PIX.

Greets,

Norbert

108
Views
0
Helpful
2
Replies