IOS and remote vpn client.

[wtashley]

I am trying to connect a remote vpn client using the vpn client software, with my router. The client has a firewall and nat on their side.

The client is able to connect and recieves an IP address from my IP pool, but it can not send or recieve traffic after that point.

What do I need to do on the router to allow for transport tunneling over udp?

Does the client need to open up specific ports to allow this to happen?

Will utilizing transport tunneling even solve my problem?

[jackko]

one way to verify is to test the remote vpn access yourself either from home or via a dial-up.

[wtashley]

I have run tests with a client from home, and I am able to connect but only without transport tunneling enabled.