How can I bind a particluar MAC to a particular IP address. I know DHCP can do that like static bindings. But incase a user has admin rights on the pc, DHCP initially assigns the IP as per the binding but later on the user can change the IP as he has full access. So is there any way like say in the core that handle L3 traffic for this vlan, I can check that say xxxx.xxxx.xxxx show be using only IP 10.x.x.12, incase it comes from another IP 10.x.x.14 then drop it.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...