Unicast Reverse Path Forwarding (Unicast RPF) can be optionally configured. Unicast RPF is used to verify that the source address is in the Forwarding Information Base (FIB). The ip verify unicast vrf command is configured in interface configuration mode and is enabled for each VRF. This command has permit and deny keywords that are used to determine if the traffic is forwarded or dropped.
2. configure terminal
3. interface type number [name-tag]
4. ip policy route-map map-tag
5. ip verify unicast vrf vrf-name deny | permit
How different is this command from :
ip verify unicast source reachable-via any allow-self-ping ( Can this command be used on VRF interfaces)
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...