IPsec and IP Nat on the same Cisco Catalyst 6000

[mgcisco]

I have an Cisco Catalyst 6506 with SE II/ MSFC II and WS-SVC-IPSEC-1.

We want to NAT our IP Address for the costoumer and connect the costoumer

over VPN to Network.

Folwing NAT Construction does we need:

IP NAT Source Dynamic and VPN IPsec with CA

IP NAT Source Static and VPN IPsec with CA

IP NAT Destination Static and VPN IPsec with CA

IP NAT Source Source Dynamic // IP NAT Destination Static and VPN IPsec with CA

IP NAT Source Source Dynamic // IP NAT Destination Dynamic and VPN IPsec with

Does it work on one Device ?

I found only IP NAT without IP Sec on same Device.

[drolemc]

Are you trying to build a IPSec tunnel for addresses which are natted. The best way to see how it is done would be to refer to the configuration example at http://www.cisco.com/warp/public/707/static.html. In this example, the private_LAN- to-private_LAN traffic has been specifically configured not to be natted.