Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPSEC and NAT

Hi:

I want to establish a VPN LAN to LAN over IPSEC through a PIX Firewall, I have a VPN concentrator 3005 in a DMZ in my PIX and the cliente has a FREESWAN linux, I am using a NAT for the ip address of the public interface of the VPN 3005.

The VPN never goes up, client receive messages about two diferents address in my side (real and nat adress).

It is possible to use nat and ipsec in other devices no-cisco?

I tested the VPN out of the PIX Firewall and it works OK.

What issues can i check?

Thank you.

1 REPLY
Bronze

Re: IPSEC and NAT

Hi,

should work just fine, make sure that u have static NAT on the pix for vpn3k, and udp 500 , ESP protocol are opened up.

96
Views
0
Helpful
1
Replies
CreatePlease to create content