I am configuring an IPsec tunnel between routers from a spoke to a hub. When I define traffic that needs to be encrypted using ACL, can I define spoke network to any destination on the spoke router and on the hub router define any source network to the spoke network? Because spoke site is getting to the Internet through the hub site and I want to encrypt all traffic on that circuit between spoke and hub. Thank you!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...