I am a novice so bear with me. When I authenticate thru the cisco vpn and do a status command, it says IPsec is not active. How do I enable IPsec. I am patched to a Linksys hub which is connected to a Cisco 806 router which is connected to a cable modem. Where is IPsec set up at? Any help would be appreciated, thanks
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...