We poll from our datacenter network (10.1.1.0/24) to the 10.200.254.1 IP every 60 seconds just to monitor UP/DOWN status of the T1. Our monitoring software stops monitoring from Midnight to 5:30 am, so we dont get alerts etc. I have the problem of the SA not being established when monitoring resumes due to the timeout. Because of the central site using an dynamic map, I can't reestablish the SA. I have to telnet to the T1 router and ping the monitoring server with a source of the 10.200.254.1 interface to restablish then all is well.
Is there any other way to keep the SA active? I know with EasyVPN I can use the nem-st-autoconnect option to keep all the SAs up, Is this an option for ann L2L tunnel?
I would prefer to have the site use EasyVPN but is it possible to route the 3 necessary networks across the EasyVPN connection? How would that config look? Thanks in advance.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...