Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPSEC Tunnel between JUNIPER (SSG 20) and CISCO PIX 501

I have successfully established the IPSEC tunnel with juniper firewall by using cisco Pix 501 (6.3 version). The problem I am facing, I have network layer connectivity but after time interval I am not able to send the traffic on destination IP address on specific port, but can successfully PING the destination IP. On both firewalls the IPs are permitted for all ports.

1 REPLY
New Member

Re: IPSEC Tunnel between JUNIPER (SSG 20) and CISCO PIX 501

Dear Mr.

The same problem has occured with me.

802
Views
0
Helpful
1
Replies
CreatePlease to create content