I have a problem on ipsec tunnel. I have a host with fixed public IP and two or more remote host. There is worked fine between remote and host. But I got the problem on remote to remote using host as gateway. It did not work. Do you have any comments? Please advice.
The story are we have one Cisco 1710 and two Linksys BEFVP41. I am using the ipsec to connect to central Cisco 1710. I want to archive that 1710 acts as a HUB and Linksys can communicate with another side of LinkSys. There is my point. Now, I can connect to central only. I cannot communicate with the other side of LinkSys.
Cisco Network is 10.2.0.0/24
LinkSys1 Network is 10.2.1.0/24
LinkSys2 Network is 10.2.2.0/24
I have set the remote is 10.2.0.0/16 and local is 10.2.1.0/24 on the LinkSys1 and LinkSys2 is remote 10.2.0.0/16 and local is 10.2.2.0/24.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...