Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPSec VPN from PIX 6.33 to Checkpoint-1 4.1 sp6

I have build a VPN between 2 offices, Phase-1 completes and phase-2 shows SPI's, but I am unable to pass traffic to one of the two subnets defined in the encryption domain ACL's. The units are configured correctly as far as I can see, but packers are droped at the checkpoint from the PIX with incorrect proposal chosen message on the CP. Has anyone seent his issue or does anyone know of a workaround?

1 REPLY
New Member

Re: IPSec VPN from PIX 6.33 to Checkpoint-1 4.1 sp6

Yes I have seen it many times. The problem is with the configuration. I know that you have probably checked your configuration over and over but double check the encryption rule in the Checkpoint.

Good luck..

99
Views
0
Helpful
1
Replies
CreatePlease login to create content