Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IPSec VPN using loopback addresses

Hi all,

I'm trying to set up (what I thought to be) a simple IPSec VPN connection between two routers using the loopback addresses as endpoints but I am having big problems implementing it. The tunnel goes from R1 to R3 through R2 and the IGP used is EIGRP. I've attached the configuration files for both routers.

When I try to do an extended ping from F0/0 on R1 to F0/0 on R3, it fails. With a "debug ip packets" on R3 I see that the source of the IP packets received is 100.1.1.1 (Se1/0 on R1).

What am I missing here to make all this work?

Thank you so much

Eduardo

1 REPLY
New Member

Re: IPSec VPN using loopback addresses

Case closed.

Right after I posted the question I found a mistake on the config:

"crypto map mymap local-address Loopback0"

should be

"crypto map myvpn local-address Loopback0"

Sorry for the bad post...

517
Views
0
Helpful
1
Replies
CreatePlease to create content