Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Is this too much logging? for routers?

I have been looking at secure IOS templates and other router security guides.

I would like to configure logging to a syslog server...thats no problem. I will also use an AAA server.

my question is: if I activate log-input on each acl permit and deny as will as the "ip accounting access-violations" command. Are those logged to the syslog server? once I have syslogging enabled?

1 REPLY
Cisco Employee

Re: Is this too much logging? for routers?

There shouldn't be a problem logging the messages to the server, but make sure that your Syslog Server can handle the amount of messages that this might end up being. I've seen limits in syslog server software and ACL hits or messages from a PIX can often overwhelm the syslog server.

158
Views
4
Helpful
1
Replies
CreatePlease to create content