Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

isakmp identify hostname ??

Hi,

i have a problem to put the line "isakmp identify hostmane" into a pix config. The pix accespt the command, but it isn´t in the config.

6.3.3 with pix 515

crypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmac

crypto map outside_map 10 ipsec-isakmp

crypto map outside_map 10 match address outside_cryptomap_10

crypto map outside_map 10 set peer x.x.x.x

crypto map outside_map 10 set transform-set ESP-3DES-MD5

crypto map outside_map 10 set security-association lifetime seconds 360 kilobytes 1000000

crypto map outside_map interface outside

isakmp enable outside

isakmp key ******** address x.x.x.x netmask 255.255.255.255

isakmp policy 10 authentication pre-share

isakmp policy 10 encryption 3des

isakmp policy 10 hash md5

isakmp policy 10 group 2

isakmp policy 10 lifetime 10800

2 REPLIES
Silver

Re: isakmp identify hostname ??

that is because that is the default for the isakmp identity command. default settings are not shown in the config because the config does not change them

New Member

Re: isakmp identify hostname ??

Hi,

ok, that can be true. But the pix try to identify once with the address and once with the hostname.

I hava a FSecure on the other side whitch only identify with the hostname.

Regards, Sebastian

101
Views
0
Helpful
2
Replies
CreatePlease login to create content