12-18-2006 07:23 PM - edited 02-21-2020 01:21 AM
I have configured a Linksys VPN router and a PIX as a site to site.
When I run the debug cry commands on the PIX, I am always receiving the following message:
"ISAKMP (0): retransmitting Config Mode Request..."
I have searched the Cisco site and the Web and cannot find anything definitive as to what is causing my error.
When I perform a "sh isa sa" on the PIX, I get the following:
state = OAK_CONF_ADDR, but I cannot reference that either.
What are these debug outputs telling me?
Thx
Solved! Go to Solution.
12-19-2006 05:04 AM
when configuring IPSec with non-Cisco devices, always turn off xauth (add command no-xauth)
change command specifying isakmp key
isakmp key your_key address your_address no-xauth
M.
Hope that helps rateif it does
12-19-2006 05:04 AM
when configuring IPSec with non-Cisco devices, always turn off xauth (add command no-xauth)
change command specifying isakmp key
isakmp key your_key address your_address no-xauth
M.
Hope that helps rateif it does
12-19-2006 08:00 AM
Yes. I ended up digging up an old config and saw two statements: no-xauth and no-config-mode. Once I put both of those on the statement ( as your example illustrates) I was able to connect the sites together.
Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: