Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

ISDN backup for VPN between VPN3000 and Router

Hi,

in our central site we have a VPN3015 concentrator and a 3640 with ISDN PRI interfaces. In our remote locations we are using 1720s with IPSec for the internet connection (Ethernet) and additional ISDN ports.

How can we establish an automatic ISDN backup for the VPN connection ? Is it possible somehow using OSPF ?

Thank you very much.

3 REPLIES
Community Member

Re: ISDN backup for VPN between VPN3000 and Router

Hi,

I think you can enable the OSPF in the VPN 3015. The problem is that the OSPF will not be able to cross the VPN tunnel from VPN 3015 to build up the neighbor with remote end.

So you need enable reverse-routing ejection in the VPN 3015, advertise the routes through OSPF advertise the reverse routes from remote VPN sites to the 3640.

In the 3640, you can enable dialer-watch to watch remote network, when the remote nework disapeared from the routing table, (VPN3015 VPN tunnel down), the ISDN will come up, then it should be working fine.

Check following two url for more details with RRI:

http://www.cisco.com/warp/customer/471/rri.html

Best Regards,

Community Member

Re: ISDN backup for VPN between VPN3000 and Router

Hello,

using RRI might switch the routes in our central site, but how can I force routing using the ISDN on the remote routers ? Is there any way to change routing based on the existence of an IPSec tunnel (if the physical interface is up in both cases) in IOS ?

As far as I know GRE tunnels are not supported in VPN3000, so there is no option to use a tunnel interface on the routers ?!

You mentionend to give two URLs, but I can see only one. Perhaps the missing one will answer my questions ?!

Best regards,

Community Member

Re: ISDN backup for VPN between VPN3000 and Router

If you wanted to use GRE and IPSec tunnels, you could build the IPSec tunnel to the VPN 3000 and then the GRE tunnel to a different router behind the 3000.

If the whole point is to let the remote site router know when the VPN is down so it can dial it's ISDN, how about using BGP between some router at your central location and your remote site router. Announce some arbitrary route and use dialer watch on that route.

115
Views
12
Helpful
3
Replies
CreatePlease to create content