Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN status

Dear sir

I m unable to see show isdn status command for PRI on my 2801 and 3745 router.I have tried

c2801-ipvoicek9-mz.124-15.T4 and c2801-spservicesk9-mz.124-11.T with 2801.

Kindly help me out

  • Other Security Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ISDN status

I'm guessing you don't have the pri-groups defined in your config.

Not an IOS issue but a configuration issue.

5 REPLIES
Cisco Employee

Re: ISDN status

could you put the relevant show run output and show controller t1.

Were these once working T1's or are they newly installed?

Cisco Employee

Re: ISDN status

could you put the relevant show run output and show controller t1.

Were these once working T1's or are they newly installed?

New Member

Re: ISDN status

rosalza

actually these are newly installed PRI.

I have using vwic-2MFT.g703 and and Vwic-2MFT-E1.

my controller is

controller e1 0/0/0 and controller e1/0/0/1

could u plz clear me is it a IOS issue or something else

Cisco Employee

Re: ISDN status

I'm guessing you don't have the pri-groups defined in your config.

Not an IOS issue but a configuration issue.

New Member

Re: ISDN status

thanks rozalaza

i was missing pri-g

132
Views
0
Helpful
5
Replies
This widget could not be displayed.