Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

L2 OOB and L3 OOB at the same time

Can you run L2 OOB and L3 OOB at the same time?

I have a core 6509 and it is trunked to access layer switches “ 4506 and 2960s”.

The problem is that I am installing a 3845 router” off the 6509” to act as a hub for crypto tunnels. The spokes will be 2821 routers with 2960 switch on its own subnet that requires routing not L2.

Could someone provide a good example of configuration? Most confused with the CAS.

In the above need do I have E0 and E1 in different VLANS with different IP's.

Using a 10.x.x.x /24 private address network.

1 REPLY
New Member

Re: L2 OOB and L3 OOB at the same time

Yes you can run layer 2 and layer 3 in other words client adjacency is 0 hops from cas in respect to the 6509 and multi hops in respect to the 2960 switches at the remotes.

Unfortunately its not as simple as providing you a working config getting this set up is usually a 1 week process for most cisco partners.

137
Views
0
Helpful
1
Replies