Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lan to Lan routing help needed

I am trying to set up a Lan to Lan connection for home users to connect back to the main office. I am using a ASA 5505 for the home and connecting back to a 3005 concentrator.

I have the tunnel built and working. When interesting traffic orginates at the remote client, the tunnel is built correctly.

My issue is that I cannot get the routing to update on both sides.

I have enabled RIP on both sides and set the 3005 to use network autodiscovery to update the routing table on both networks.

I either dont have the RIP configured correctly, or I need to enable the NAT rules, but its not making sense to me.

Any help?

1 REPLY
New Member

Re: Lan to Lan routing help needed

Hi,

Add the following line under the crypto map mode

reverse-route remote-peer

Regards,

Elly

135
Views
0
Helpful
1
Replies
CreatePlease to create content