Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LAN-to-LAN tunnel, need to show Public IP

I have to setup a vpn tunnel from my router to a remote company. We are accessing a public ip on their side. The issue is that want to see a public ip from me. How do i create a vpn tunnel to them and have them see a public ip for my internal server that is connecting to them

1 REPLY

Re: LAN-to-LAN tunnel, need to show Public IP

Hi .. you might need to create a static translation for your internal server ie.

ip nat inside source static privateIP public-IP

And then add that communication to the IPsec interesting traffic. The remote site needs to allow traffic from their internal network to the Public-IP as part of the Ipsec interesting traffic. On your site you need to create the static, add that communication to the ipsec interesting traffic and make sure you add an exeption nat { deny} from any packet sourced from you private server .. confused ..?

The below link shows an example of what you need to do

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094634.shtml

I hope it helps .. please rate if it does !!!

105
Views
0
Helpful
1
Replies
CreatePlease to create content