Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Lan-to-Lan VPN with ASA5520

I recently purchased an ASA5520 and am beginning to migrate my VPN tunnels from a 3005 concentrator to the ASA. I noticed there does not seem to be a way to monitor the tunnel connections by NAME, like on the concentrator. It does display active tunnels by IP address but I will soon have over 200 tunnels. I would like to see a "name" rather than an IP address when I monitor. Any thoughts how this could be accomplished?

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Lan-to-Lan VPN with ASA5520

Try using the "name" command. The "name" command associates a name with an IP address. See the following page for more information on the "name" command.

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/no_711.htm#wp1645754

2 REPLIES
Bronze

Re: Lan-to-Lan VPN with ASA5520

Try using the "name" command. The "name" command associates a name with an IP address. See the following page for more information on the "name" command.

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/no_711.htm#wp1645754

New Member

Re: Lan-to-Lan VPN with ASA5520

That worked. Thanks. Its a shame, however, that the names can't be entered in the ADSM interface ... unless it can and I don't see how. I've just telnetted to the box.

144
Views
5
Helpful
2
Replies