Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

layer 3 on 4006 switch

i have two vlan on my switch which has layer 3 module.i have built two subinterfaces for connecting

these two vlans through inter vlan routing.

but i can not ping from one vlan to other side

without having route add on my windows 98 on both side.

how can i see another vlan without add command in

my windows

3 REPLIES

Re: layer 3 on 4006 switch

The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you.

We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: layer 3 on 4006 switch

What are you using to do inter vlan routing. A router or some MSFC card?

Can you ping from the one router interface to other.

If you can tell me wha texactly you are doing, i prob can help u

New Member

Re: layer 3 on 4006 switch

You need to configure routing between your VLANs. Take a look at http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/inst_nts/78_10164.htm#24106

149
Views
0
Helpful
3
Replies
CreatePlease to create content