Not sure I fully understand what you are asking but it sounds like you are asking if it is possible to load balance your outbound connections across two seperate pipes? If so, this would be possible using OSPF Equal Cost Multi Path (ECMP). Essentially this works by having both internet routers advertise a default route to the PIX. The PIX installs both routes and then uses an algorithm to determine which path to send the traffic. You may need to work this out with your ISP(s) and install BGP routes on the internet routers to advertise out your address space. And you will need at 6.3 code on your PIX to pick up OSPF support. Hope this helps.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...