Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Loading PIX config from TFTP server ??

I have a 506E running 6.3(4) and I'm writing the config off to my TFTP server. I don't see a way to reload the config from the TFTP server (like with IOS). Is it capable or am I approaching it the wrong way?

-Steve

3 REPLIES
Silver

Re: Loading PIX config from TFTP server ??

Use the tftp-server command to define the server address and the config net command to reload from that server. Check the command reference below if you need additional information on these commands.

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727ae.html#wp1026054

Hope this helps.

Steve

Community Member

Re: Loading PIX config from TFTP server ??

configure net is the command you need. write net puts the config out there and confugure net brings it from the tft back to the firewall.

Best,

Brandon

Re: Loading PIX config from TFTP server ??

for your info,

The following example shows how to configure the PIX Firewall using a configuration retrieved with

TFTP:

configure net 10.1.1.1:/tftp/config/pixconfig

The pixconfig file is stored on the TFTP server at 10.1.1.1 in the tftp/config folder.

I hope it helps .. please rate it if it does !!!

281
Views
0
Helpful
3
Replies
CreatePlease to create content